1. Wipe off hand grease and soiling thoroughly with the Geist. Degreaser D1, let it dry then test the surface adhesion on the damaged area with a simple tape test. If normal low-tack masking-tape  does not stick to the surface, clean again until it does, then lightly sand the damaged surface with a circular motion using the Geist. Leather Sanding Pad. Remove dust.

2. Apply Geist. Easy Filler by pressing the tube-tip down into the damaged area. Smooth the filler surface with a finger or flat tool and leave to dry slowly without heat.

3. For additional smoothing, wet-sand the now-dry filler with Geist. Dissolve. 

Colouring after repair:

Apply Geist. Easy Colour Restorer to the cleaned and repaired leather surface, following the instructions supplied. 

Additional protection in heavily used areas such as on car entry areas or steering-wheels. Is recommended. Geist. Dye & Friction Blocker is an excellent additional shield against friction damage which shows over 300% higher protection than other shield-type products in laboratory friction tests.

Attention:

• Do not use on suede, nubuck, velour or microfibre (Alcantara) type surfaces. 
• Always test on an unseen area before use.
• The long-term effectiveness of the Geist. Easy Filler depends on the thoroughness of the surface cleaning and degreasing before application.
• Store away from the reach of children.
• In case of contact with the eyes rinse thoroughly with water. If irritation persists, contact a doctor.

Safety Data Sheets in each language:

• English (UK)
• English (USA/CA)